It is a hand tool used for squeezing, bending, and cutting works in situations where it is difficult and impossible to hold the parts by hand.
The working logic is similar to scissors. The handle is grasped with the palm. It provides grip as much as the amount of pressure you apply. The serrations between the jaws prevent the part from slipping. There are two opposing notches on the chin. These notches make it easier to grip pipes and round parts. In addition, there is a scissors section at the bottom of the chin. This part can be used as a side cutter for cutting and stripping cables. Steel Plier must-have hand tool in every home.
Crow Nose
It is a kind of plier. The jaws are more extended and sharper than the pliers. It facilitates the holding, crimping, bending, and cutting jobs required in tight spaces where pliers cannot fit. It creates a weaker clamping force than pliers.
As a working system, it is like scissors. The handle part is placed in the palm. It creates gripping force as much as the tightening force you apply. The serrations on the inside of the jaws prevent the workpiece from slipping. There is a half-moon-shaped notch on the chin. There are cutter jaws that provide shearing in the inner and lower parts of the jaw. These make it easier to hold round cylindrical materials. Wire cutting and cable plastic stripping can be done quickly.
Fort Pliers
It is wholly produced for holding and tightening. Bolts are used to tighten or fasten round, flat parts.
The jaw opening is adjusted according to the thickness and width of the material to be squeezed. Optimal tightening is provided by hand power. It has adjustable steps to increase or decrease the jaw opening.
Wrench
It is a hand tool produced only for strong tightening and fixing. Thanks to the screw system under the handle, the gap between the jaw and the part is reduced. The handle part is tightened by hand and fixed with the lock system on it. Thanks to the locking system, it keeps the part stable and does not let go. Since the jaw part is ideal for round and cylindrical parts, it can be easily used in installation processes.
Curved nose Pliers
Curved needle nose plier is helpful for holding, opening, and refitting the circlips. They only use it for segments. The tip of the ring may vary depending on the type and place of use.
There are two holes in the segment used for opening and closing. Holding is provided by placing the two ends of the pliers into the slot.
Segment: It is a steel spring produced to seat the parts placed on the shaft or cylinder or play in a fixed area. It is also used as a sealing element in pistons.
Side Chisel
The side cutter allows to cut products such as cables and wires and open the plastics on the wires.
It is generally used by electricians and people dealing with this kind of work. They have cutting jaws that meet each other perfectly and act like scissors. It provides tearing by notching the wire or breaking it by cutting it directly.